TABLE MAINTENANCE
Hand smudges, paddle scars, etc. can be wiped off using a mild soap, warm water and a
soft rag. The plastic surfaces on the legs and bumpers can be similarly cleaned. In
time, the bumpers will get hard and crack due to the ultra-violet sun rays. They can be
periodically replaced by placing an order to Poly Pong, Inc. This is true for any part of
your table.
The table colors are also susceptible to the ultra-violet rays. The paint contains UV
inhibitors but it eventually will fade. Yellow is the most susceptible to attack. Any of
the colors can be recoated. Use Valspar LIC43 low gloss Polyurethane Enamel of the
desired color. Mix with LK40 polyurethane LIC activator, four parts LIC to one part
LK40. One quart will easily coat a table top. The yellow top is John Deere yellow.
Black surfaces are coated with Sherman Williams paint Hi-Solids Polyurathane B65
TWJ 304 with B60V20 activator.
The process is:
1. Remove the bumpers by removing the two screws that hold each to the table..
2. Clean the surface thoroughly with a mild soap. Rinse thoroughly.
3. When dry, sand lightly with 320 grit sand paper.
4. Mask off the table joiners and any other nearby surfaces
5. Apply by roller or spray a good quality acrylic paint, one that has a good UV
inhibitor rating and requires a hardener to be stirred into the mix.
6. When it is thoroughly dry, remove the masking tape and replace the bumpers.
Page 15
POLY PONG, INC
412 South 100 East
Salem, Utah 84653
www,polypong.com
1-801-473-1321
