L
ook carefully and you will notice four bolt holes on the lower outer lip of the “I” beam.
(There are four on the inside as well.) Carefully re-position the beam slightly so that
these holes align up with four imbedded nuts it the table tops. Using 8 mm by 20 mm
screws and SMALL washers, attach the beam to the table tops. LEAVE THESE
SCREWS LOOSE. Fig 15.
Fig. 14
Fig. 15
Now do the same for the four holes on the inside of the beam. Use 8 mm x 20 mm
screws and small washers. The beam may need to be re-positioned slightly. Fig. 16.
Two of these screw holes are on the far side of the leg assemblies under the beam
covers. LEAVE THESE SCREWS LOOSE. Fig. 16.
Fig, 16
PAGE 7
