Configure H.323 Settings
If your network uses an H.323 gatekeeper, the system can automatically register its H.323 name and
extension. Others can then call the system using its H.323 name or extension instead of its IP address.
Procedure
1.
In the system web interface, go to
Call Configuration
>
H.323
.
2.
Configure the following settings:
Setting
Description
Enable IP H.323
Enables the system to display H.323 settings and
configuration options.
Registration Status
Read-only setting shows if your system is registered
with an H.323 gatekeeper.
H.323 Name
How gatekeepers and gateways identify your system.
You can make point-to-point calls using H.323 names if
both systems are registered to a gatekeeper.
The
H.323 Name
is the same as the device name
unless you change it.
Your organization’s dial plan might define the name you
can use.
H.323 Extension (E.164)
You can place point-to-point calls using this extension if
both systems are registered with a gatekeeper.
Gatekeepers and gateways also use the extension to
identify your system.
Your organization’s dial plan might define the
extensions you can use.
Use Gatekeeper
Specifies if you want to use a gatekeeper for H.323
services.
▪
Off
: Calls don’t use a gatekeeper.
▪
Auto
: System tries to automatically find an available
gatekeeper.
▪
Specify
: Calls use the specified gatekeeper. You
must select this setting to enable H.235 Annex D
Authentication.
If you don’t configure this setting to
Off
, a registration
status displays.
Configuring Network Settings
41
