This Configuration Guide is written as general guide on how to configure the Poly Edge B30
phone model to work with PBXware 6.6.1.
Requirements
Identifying phone model
To start and successfully complete registration of your Poly Edge B30 phone you need to know
which phone model you will setup.
From the back of each Poly Edge B30 phone there are exact model information that you should
check. Although different phone models can have exactly the same requirements and
installation procedure, phone models can also have significantly different requirements and
installation procedure, so that ignorance of your own model may result in the inability to
successfully set up your phone.
Phone firmware
Make sure that your phone is loaded with appropriate firmware version,
1.0.1
.
■
To find out the firmware version of your Poly Edge B30 phone model open a new browser
■
window and enter your phone IP address in order to access the phone web administration
interface login screen. Example: http://192.168.1.22.
Login to phone web administration interface with your username and password. Please note,
■
