Setting
Description
Transfer Frequency
Specifies when the system transfers logs:
•
Manual
: The transfer starts when you select the
Start
button, which is visible only in the local
interface. If the log fills before you transfer, new
events overwrite the oldest events.
•
Auto at Threshold
: The transfer starts
automatically when the system reaches the
Percent Filled Threshold
.
3.
Select
Save
.
Configure Log Level
You can determine how much detail you want in your system logs.
Procedure
1.
In the system web interface, go to
Diagnostics
>
Logs
>
System Log Settings
.
2.
Configure the following settings:
Setting
Description
Log Level
Sets the minimum log level of messages stored in
the system’s flash memory. Poly recommends that
you use the default value.
When you enable remote logging, the log level is
the same for both remote and local logging.
Set one of the following log levels. Poly
recommends that you enable automatic transfer of
logs to a USB flash drive when using one of these
setting.
•
Debug
: Logs all messages.
•
Info
•
Warning
•
Critical
: Logs the fewest number of messages
Enable H.323 Trace
Logs additional H.323 connectivity information.
Poly recommends that you enable automatic
transfer of logs to a USB flash drive when using
this setting.
Enable SIP Trace
Logs additional SIP connectivity information. Poly
recommends that you enable automatic transfer of
logs to a USB flash drive when using this setting.
3.
Select
Save
.
Troubleshooting
105