![background image](http://html.mh-extra.com/html/poly/g7500/g7500_administrators-manual_1575582021.webp)
Related Links
on page 72
Choose Speakers When Paired with Poly Trio
on page 92
Configure a Poly Trio for Pairing
To pair with a video system, you must configure your Poly Trio system’s base profile and device role.
Procedure
1.
On the phone’s local interface, go to
Settings
>
Advanced
>
Administration Settings
>
Network Configuration
.
2.
Set the
Base Profile
to
Generic
.
3.
After the phone restarts, go to
Settings
>
Advanced
>
Networked Devices
.
4.
Set
Networked Device Role
to
Device
.
The system automatically restarts.
Pair an IP Device on the Primary Network
Some devices connected to your primary network can pair with your video system. For example, this
feature enables you to pair a Poly TC 8 device without a physical connection to the video system.
Note:
Pairing IP audio devices and cameras over the primary network isn’t supported.
To pair, the device must be on the same subnet as the video system and the following network
components must be unblocked:
▪ Multicast address 224.0.0.200
▪ TCP port 2000
▪ UDP port 18888
Know the MAC address of the device you’re pairing.
A device may pair automatically after connecting to the network. However, you may need to manually pair
a device in the following situations:
▪ The device doesn’t automatically pair during setup with the system you purchased.
▪ You want to pair the device with a different system.
▪ You want to pair multiple similar devices (for example, to control the system with more than one
Poly TC8 device).
Note:
The
Enable New Device Auto-Pairing
setting applies only to link-local network (LLN) devices;
not devices connected to the primary network.
Procedure
1.
Connect the device you want to pair to an Ethernet port in the room.
2.
In the system web interface, go to
General Settings
>
Device Management
.
3.
Under
Available Devices
, find the device by its MAC address (for example,
00e0db4cf0be
) and
select
Pair
.
If paired successfully, the device displays under
Connected Devices
with a
Connected
status. If
a device shows a
Disconnected
status, this indicates that pairing wasn’t successful.
Setting Up the System
20