Your headset comes pre-paired to the base. To pair again:
1
Press the headset Call button until you hear "pairing" and the headset LEDs flash blue and red.
2
Put your base into pair mode by pressing and holding the Bluetooth pairing button on the back
of your base for 2 seconds until the display panel's Bluetooth icon flashes blue and red.
Pairing is successful when you hear "pairing successful" and "base connected" and the display
panel's Bluetooth icon turns solid blue.
NOTE
Your headset can pair with up to 8 devices but only maintain 2 connections simultaneously;
this includes the base.
1
To put your headset in pair mode, press the Call button until you hear "pairing" and the headset
LEDs flash blue and red.
2
Activate Bluetooth on your phone and set it to search for new devices.
•
iPhone
Settings
>
Bluetooth
>
On*
•
Android
Settings
>
Bluetooth: On
>
Scan for devices*
NOTE
*Menus may vary by device.
3
Select “PLT V5200 Series.”
If necessary, enter four zeros (0000) for the passcode or accept the connection.
Once successfully paired, you hear “pairing successful” and the headset LEDs stop flashing.
NOTE
Your headset can pair with up to 8 devices but only maintain 2 connections simultaneously;
this includes the base.
With your headset powered on, press the Call button until you hear "pairing."
Pair
Pair again to base
Pair to mobile device
Pair mode
8
