Your system has a base and compatible Bluetooth headset.
Your headset comes pre-paired to the base. To pair again:
1
Slide and hold the headset Power switch away from the off position until the LEDs flash
red and blue.
2
Put your base into pair mode by pressing and holding the Bluetooth pairing button on the
back of your base for 2 seconds until the display panel's Bluetooth icon flashes blue and
red.
Pairing is successful when you hear "pairing successful" and "base connected" and the
display panel's Bluetooth icon turns solid blue.
NOTE
Your headset can pair with up to 8 devices but only maintain 2 connections
simultaneously; this includes the base.
1
To put your headset in pair mode, slide and hold the Power switch away from the off
position until you hear "pairing" and the headset LEDs flash red and blue.
2
Activate Bluetooth on your phone and set it to search for new devices.
•
iPhone
Settings > Bluetooth > On*
•
Android
Settings > Bluetooth On > Scan for devices*
NOTE
*Menus may vary by device.
3
Select “PLT V4210 Series / PLT V4220 Series.”
Once successfully paired, you hear “pairing successful” and the headset LEDs stop flashing.
NOTE
Your headset can pair with up to 8 devices but only maintain 2 connections
simultaneously; this includes the base.
Slide and hold the headset Power switch away from the off position until the LEDs flash
red and blue.
Pair
Pair headset to base
Pair to mobile device
Pair mode
8
