Appendix B: Remote Configuration Parameters Definition
PN: 1725-36038-001_N.docx
149
Parameter
Allowable values
1
Default
2
Assoc
info
3
Causes
reboot
CALL_LOG_ENABLE
0,1 (0=disable,
1=enable)
0
no
Version 2 Configuration Table Notes
Footnotes
1.
The allowable values column specifies the allowable values that
can be set using the version 2 configuration parameter. The
allowable values for the same configuration item in HAT and
menus may not adhere to these listed allowable values.
2.
Default means the value used if no value is specified in the
saved parameters on the phone (from HAT, Admin menus or
previous initialization of phone), or from DHCP or a
configuration file. Or the value has been cleared using NULL.
3.
The Assoc info column indicates when the parameter is used or
ignored. Specifically it is to indicate:
•
Which IP addresses belong to the group called static IP
addresses. These appear on the IP Address menu in the
Admin menus and HAT.
•
The security type that a label goes with (e.g., WPA_PSK is
used only with security types WPAPSKand WPA2PSK).
•
Which power variables go with which radio modes.
•
WMM_ACCESS_CONTROL is only used for WIFI
Standard QOS.
4.
The SYSLANG parameter value will always be overridden by
any user entered language. That is, this parameter will take
effect only if the user has not modified the language via the
standby menus since the last restore defaults.
5.
GMTOFFSET: Valid values are a positive or negative number
of hours and minutes less than 13 hours. 1 to 6 ASCII
characters, optionally beginning with “+” or “-”, followed by
one or two ASCII numeric digits whose combined value is from
0 to 12, optionally followed by a “:” and 2 ASCII numeric digits
that can be any of 00, 15, 30, or 45. Other minute values in the
range 01 to 59 will not generate an error but will be interpreted
as if they were 00. Minute values not 2 digits long will be
rejected.
