PN: 1725-36038-001_N.docx
49
Download and Install Handset
Software
SpectraLink 8020/8030 Wireless Telephones support a number of
different IP protocol integrations. All SpectraLink 8020/8030 Wireless
Telephones are shipped from Polycom with a generic software load
that allows them to associate to a wireless LAN and download
functional software from the provisioning server.
The handsets will
not function properly without downloading appropriate software.
The following details the process to properly configure SpectraLink
8020/8030 Wireless Telephones and download software via over-the-
air file transfer.
You may need to charge the handset first. See
Minimum Configuration Process
Recent hardware changes affect the Polycom SpectraLink
8020/8030 Wireless Telephones. The affected products can be
identified by a “Rev C” on the label.
The minimum version if you have a Rev C handset is
131.029
.
Any attempt to load earlier versions will result in a download failure.
See Appendix D for full information.
The handset requires minimum configuration in order to associate
with an AP. Once the network is accessed, the remaining
configuration parameters can be automatically obtained through the
configuration files if using Version 2 Configuration mode . If Version
2 Configuration files are not used, non-SIP parameters may be
configured by using the HAT tool or manually using the Admin
menu on each handset and entering the configuration information.
The options are listed below in decreasing order of efficiency:
•
HAT plus Remote Configuration (Version 2): Use the HAT tool to
set minimum parameters in each handset and then turn on the
4
