PN: 1725-36038-001_N.docx
87
Using the 8020/8030 Handset
The handset's Battery Pack must be fully charged before its first use.
Place the handset into the charger for a minimum of two hours before
using it.
For complete operational instructions see
Wireless Telephone and Accessories User Guide for SIP
Startup Sequence
The SpectraLink 8020/8030 Wireless Telephone goes through an
initialization sequence at startup. The line icons 1-9 display and count
down as the handset steps through this sequence. This is usually very
rapid. If there is difficulty at any step that prevents initialization from
continuing, an error message will display and the related icon(s) will
stay on. Please see the error table at the back of this document for
instructions on how to handle error messages that occur during
initialization.
Icon
The icon(s) shown in bold turns off when:
12345678
9
The handset has located and authenticated and associated with at least one AP, and is
proceeding to bring up higher-layer networking functions.
1234567
8
The handset is either configured for Static IP, or if configured for DHCP, the DHCP
discovery process has started.
123456
7
If DHCP is configured, a DHCP response was received which contains a good DNS
server configuration.
12345
6
Note: Used for SVP QoS only and not present when using Wi-Fi Standard QoS or
CCXv4.
Indicates one of the following possibilities:
1. Static IP configuration
2. SVP Server address found in DHCP option 151 response
3. SVP Server address found via DNS lookup
1234
5
All networking functions are complete (notably, DHCP), and the handset is proceeding
with establishing the SRP link to the SpectraLink 8000 SVP Server.
123
4
Note: Used for SVP QoS only and not present when using Wi-Fi Standard QoS or
CCXv4.
The SRP link is established; all network stack initialization is complete, proceeding with
8
