Configure Each SpectraLink Wireless Telephone
PN: 1725-36038-001_N.docx
63
current state. Press
NavOK
to change the password protection state. To
modify the password requirement, the default or previously set
password must be entered to verify the change.
Change
Password
will
appear only if the password is enabled. The password is disabled by
default. The password must be set in each handset for which
controlled access is desired. The password may be up to 18 characters
in length. Only numbers and letters are allowed.
The admin password can be defined in the HAT, in the Admin menu
or by using the PROCPSWD configuration setting in the Version 2
Configuration settings.txt file. HAT and Admin menus allow a wider
range of passwords than remote configuration. If you decide to set
the PROCPSWD parameter, it is limited to a maximum of seven (7)
digits. Only numbers may be used. See the PROCPSWD parameter
in
Appendix B: Remote Configuration Parameters Definition
more information.
Phone Group
An integer from 0 to 999. The default is 0. This value can be used by
the Version 2 Configuration files for specifying some parameters only
for some groups. See the settings.txt file.
Config Mode
Config Mode determines whether the handset will use Version 1
configuration files or Version 2 configuration files.
SIP Registration
Individual handsets may be configured to correspond with the SIP
configuration information in the provisioning server. If both HTTP
and TFTP IP addresses are present, the handset attempts to download
files from the HTTP server(s) first and only tries TFTP if the file(s) are
not found on the HTTP server. The handset is then automatically
identified at startup. If username and password information is not
configured in the
Admin
menu, then this information will be requested
at startup.
In either case, the username must agree with a corresponding
configuration file. See
Version 1 and Version 2 Configuration Files
Login
allows you to specify a username and password for
automatically acquiring SIP configuration information. If no
username is specified, the SIP handset will request username and
password at startup and any additional registrations specified here
are ignored.
