Polyend Dreadbox Medusa, Owner'S Manual

Copy

sequencer 

notes and

PM data

(from one step 

or pad to

another)

GRID

1. Press the REC button (it should be blinking if active)

2. Press the pad you want to copy and hold it (both 

note and PM data will be copied).  After a couple 

seconds, the OLED will indicate the step and note 

were copied.

3. While still pressing the first pad you want to copy, 

press the second pad you want to copy the data to.

4. The OLED will show a message that the first step 

was copied to the second step (e.g. “Step 3 cop-

ied to 2”)

Start/Stop

sequencer

Either

1. Press the PLAY button to start the sequencer.  

The PLAY button will be lit when the sequencer is 

playing.

2. While the sequencer is playing, press the PLAY 

button again to stop it.

3. If the sequencer is stopped and you restart it, 

it starts from the beginning of the sequence, not 

where it stopped.

Enter PM data

GRID

1. Press the REC button (it should be flashing).

2. Press the pad to select where you want to enter 

data (note: there doesn’t have to be note data 

already stored in the pad location; pads with only 

PM Data can be used like programmable buttons 

to instantly modify synth parameters on the fly).

3. Adjust any of the synth parameters.  The pad will 

now have basically a “snapshot” of programming 

parameters.

4. Lastly, if you do have a sequence already re-

corded, you can hit PLAY while REC is active and 

record PM data by adjusting synth parameters and 

values while the sequencer is running.

Edit PM data

GRID

1. Press REC button (it should be flashing after be-

ing pressed).

2. Press the pad that contains the PM data you 

want to edit (the pad should be flashing after you 

press it).

3. Adjust the desired parameters (cutoff, reso-

nance, octave, course tuning, LFO amount, etc).

4. When you’re finished editing, press the REC but-

ton again to stop editing (it should not be flashing), 

to avoid accidentally making unwanted chang-

es/edits.

14