·
·
·
To get the correct camera focus, adjust the distance between the scanner and
the object so that the red crosshairs in both the cameras intersect at the same
point on the object as shown in Figure 3. You can set the projector pattern to
FOCUS and align the red crosshairs over the crosshair of the focus pattern.
Adjust the exposure such that there are no red spots (over-exposed) or blue
spots (under-exposed) on the object. The Exposure slider can be found on the
top right corner of the screen.
After completing all the above steps, the scanner should be ready to take its first
scan. Click the
SCAN
button located on the left-hand side of the screen.
Figure 3
Figure 4
: Data of the object after being scanned