Congratulations on purchasing the HDI Carbon 3D Scanner. Here are the steps to set up the
capturing unit for 3D data acquisition. In this tutorial the HDI Carbon R3x 3D Scanner was used.
There are slight variations to the instructions depending on which model you have purchased.
Please see the following instructions to assemble your 3D scanner, most of which will be pre-
assembled.
When you receive your HDI Carbon 3D Scanner, check that all components are included:
Number
Item
1
Carbon Fiber Mount with Projector
2
2 x USB 3.0 Cameras
3
2 x Lenses (12mm)
4
Tripod Leg
5
Tripod Head
6
15mm Calibration Board
7
HDMI cable, USB 3.0 cable
8
FlexScan3D Dongle
9
Calibration Stand
10
Power cable
11
4 x Screws
