9
OWNER’S MANUAL
SETUP INSTRUCTIONS
6. Now the Pump should be installed outside the pool wall as below.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Before assembly, take a few minutes to identify and become familiar with all the parts.
Pool Inlet
Skimmer Opening
Inside Pool Wall
Inside Pool Wall
Outside Pool Wall
5
Inside Pool Wall
No gap here
thread slots
Skimmer Installation
1. Set up your pool following the pool Owner’s Manual instructions. Do NOT fill
water until the Filter Pump is properly installed. Locate the Skimmer Opening
on the pool wall.
2. Slide open the Top Cover
5
and take out the parts inside.
3. Turn counterclockwise to remove the Skimmer Seal Ring
d
. Make sure
the Skimmer Gasket Rubber Seal
h
is in the correct position.
The protruding edge of the
Skimmer Canister
9
fits
in-between the two keys of
the Gasket
h
.
Make sure that the pool liner is
placed tight on the Gasket
h
and is NOT trapped in the threads;
otherwise leaks may occur.
4. Insert the threaded part of the Skimmer Canister
9
through the Skimmer
Opening, and then secure with the Skimmer Seal Ring
d
.
To optimize water circulation,
twist the RF Diverter
p
so
that it faces up and away
from the Skimmer Opening.
Return Fitting Installation
5. Assemble the Return Fitting
o
as indicated below.
Make sure the Hose Clamps
w
seals
tightly over both the Return Hose
e
and O-Rings
q
.
