12
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
Water Capacity
(80% for Quick Set Pool,
90% for Frame Pool)
Salt Needed For Start
up 3.0g/L (3000ppm)
Salt Needed When
Low Salt Detected
Gals
2000
4000
6000
8000
10000
12000
14000
Liters
7500
15000
22500
30000
37500
45500
53000
Lbs
50
100
150
200
250
300
350
KGs
23
45
68
90
113
137
159
Lbs
13
26
40
53
66
79
92
KGs
0.45
12
18
24
30
36
42
Salt Needed For Start Up (Lbs)
Water Capacity (Gal) x 0.025
Salt Needed For Start Up (Kgs)
Water Capacity (Lite) x 0.003
Water Capacity (Gal) x 0.0067
Water Capacity (Lite) x 0.0008
Salt Needed When Low
Salt Detected (Lbs)
Salt Needed When Low
Salt Detected (Kgs)
SALT TABLE FOR COMMON NON-POLYGROUP POOLS
SALT CALCULATION FORMULA FOR ALL POOLS
POOL VOLUME CALCULATION
Pools Type
Rectangular
Circular
Oval
Length x Width x Depth x 7.5
Length x Width x Depth x 5.9
Length x Width x Depth x 6
Length x Width x Depth
Length x Width x Depth x 0.79
Length x Width x Depth x 0.8
Gallons (size in feet)
Cubic Meters (size in meters)
SETUP INSTRUCTIONS
IMPORTANT:
THE SALT WATER SYSTEM REQUIRES A SEPARATE FILTER PUMP 600-4000 GPH (2271-15140 LPH) TO DRIVE THE
WATER AND FUNCTION PROPERLY. THE SALT WATER SYSTEM MUST BE INSTALLLED AS THE LAST PIECE OF POOL EQUIPMENT
IN THE WATER RETURN LINE TO THE POOL AS DISPLAYED IN DIAGRAM.
1. Assemble the above ground pool and its filter pump according to their installation instruction manual.
2. Take the salt water system and its accessories out of the package.
3. Place the salt water system in line after the filter pump as shown on FIG.1.
4. Connect the electrolytic cell unit inlet
16
to filter pump section:
4.1 If the pool is filled with water, unscrew the strainer grids from the strainer connector and insert the black hat like plug(s) into the inlet and outlet connectors, before
installing the salt water system to prevent excessive water drainage.
4.2 Disconnect the water return hose form the filter pump connection
4.3 Make sure a strainer grid piece
15
and connecting tube
13
are properly installed onto the electrolytic cell unit inlet, lock with hose clamp
14
securely.
4.4 If needed, connect the universal hose adaptor
28
to filter pump hose, tightly.
4.5 Remove the black hat like plug(s) from outlet that prevent water from flowing out of the pool if still inplace.
5. Connect the electrolytic cell unit outlet
24
.
5.1 Connect the 1.25"(38mm) hose to the electrolytic cell outlet
24
, and lock it with hose clamp securely.
5.3 Remove the black hat like plug(s) from inlet that prevent water from flowing out of the pool if still present.
5.4 Check the electrolytic cell unit
26
for water leakage.
6. Plug in the GFCI
27
to power on the salt water system.
