13
OWNER’S MANUAL
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
FILTER/SKIMMER PUMP
SWIMMING POOL
Connecting the system to pump and pool
27
24
16
26
1. Unplug the power cord.
2. Remove outlet hose end, check inside the electrolytic cell outlet tube. Make sure it is dirt and clog free.
3. Move any debris or dirt if necessary.
FLOW SENSOR CLEANING
1. Assemble the above ground pool and its filter pump according to their installation instruction manual.
2. Take the salt water system and its accessories out of the package.
3. Place the salt water system in line after the filter pump as shown on FIG.1.
4. Connect the electrolytic cell unit inlet
16
to filter pump section:
4.1 If the pool is filled with water, unscrew the strainer grids from the strainer connector and insert the black hat like plug(s) into the inlet and outlet connectors, before
installing the salt water system to prevent excessive water drainage.
4.2 Disconnect the water return hose form the filter pump connection
4.3 Make sure a strainer grid piece
15
and connecting tube
13
are properly installed onto the electrolytic cell unit inlet, lock with hose clamp
14
securely.
4.4 If needed, connect the universal hose adaptor
28
to filter pump hose, tightly.
4.5 Remove the black hat like plug(s) from outlet that prevent water from flowing out of the pool if still inplace.
5. Connect the electrolytic cell unit outlet
24
.
5.1 Connect the 1.25"(38mm) hose to the electrolytic cell outlet
24
, and lock it with hose clamp securely.
5.3 Remove the black hat like plug(s) from inlet that prevent water from flowing out of the pool if still present.
5.4 Check the electrolytic cell unit
26
for water leakage.
6. Plug in the GFCI
27
to power on the salt water system.
FIG.1
FIG.2
Outlet
Inlet
