PH03 Comfort Inn - September 2008
Page 9 of 12
To mount the grab bars, pry back the two round snap lock fl anges on each grab bar with a screwdriver. Align the three-
hole pattern on both fl anges of the grab bars to the holes on the support rails and rivet in place using (18) PC-000102
rivets and (18) PC-000106 back-up washers.
NOTE:
(You may have to re-drill some holes to bring them into alignment
due to manufacturing tolerances.)
Step 7. Mounting the Grab Bars
PC-000102 Rivet
18 Used in this step
PC-000106 Washer
18 Used in this step
Each of the three sidewall panels has two vent
screens. On the surface of each screen there
is a date stamp symbol. The symbol goes to-
ward the center of the sidewall panel, facing
the inside
. For each of the sidewalls, insert
into the vent slot one screen from each
side and overlap the center holes of the
screens
(at the date stamp symbol).
IMPOR-
TANT -
MAKE SURE BOTH SCREENS ARE
CENTERED IN THE VENT SLOT.
From inside
the unit using a 13/64” drill bit, drill a hole
through the center hole of the screen and
into each of the side walls. From the out-
side rivet a PC-000100 rivet into the center
hole with a PC-000106 back-up washer on
the inside. From inside the unit using the
holes at the ends of the screens as guides,
drill holes through to the wall panels. From
the outside rivet the screens in place with
PC-000100 rivets and PC-000106 back-up
washers on the inside.
Step 8. Fly Screen Installation
PC-000100 Rivet
9 Used in this step
PC-000106 Washer
9 Used in this step
Slide the vent stack up through the 4” hole of the roof and down into the corresponding hole in the tank. Using a
13/64” drill bit, drill a hole through the boss on the tank and through the vent stack. Rivet into place with (1) PC-000117
rivet.
Step 9. Vent Stack Installation
PC-000117 Rivet
1 Used in this step
