2-2-1 Installing the Mechanical Stage Mounting Assembly
1. Before installing the mechanical stage mounting device, be sure to adjust the coarse focus
knob until the guide board (Figure 1) is at its lowest position. This allows you to install
the mechanical stage easily. Use the 3.0mm hexagonal Allen wrench to connect the
mechanical stage mounting support assembly and the guide board. Ensure the connection
is tight and secure.
2. Place the mechanical stage mechanical assembly (Figure 2) onto the top of the guide
board
(Figure 1). Ensure the assembly (Figure 2) is completely attached to the guide board before
tightening the allen screw.
The mechanical stage has been factory assembled and adjusted. Disassembly of the
mechanical stage should be attempted only by a trained microscope service
technician.
5
5
Summary of Contents for 3025 series
