7
network connections. These settings will be done at the PC under
”Network connections
LAN connection
“. After
individualization of the IP addresses, the network connection between the devices can be established.
Establishing a connection:
Enter the IP address of the device (Standard IP address:
192.168.001.010
) into the address field of the browser
and
press the “Enter“ key to confirm.
The connection to the device is established and the associated login window will be displayed:
The access to the configuration menu is password protected. The factory settings are as follows:
Username:
admin
Password:
admin
Note
Should the password or the username be lost or forgotten, a general factory reset can be done by pressing the
Reset button or via “System menu
Restore defaults”. The device reverts to the basic access data and basic
settings. Even individualized basic settings (except the Ethernet access data) are lost.
6.2 Home page of the device
After log-in, the device homepage will display the main information about the device and its status. File tabs for
programming the HDI 2 multi are available at the top of the window.
In the device description
“
Device information
“, the most important information about the device will be displayed.
The table displays the device type, current selected modulation type, serial number, installed software version,
hardware version, time, country and operating hours.
The
“
Diagnostic information
“ table shows the operating status of the device. If there is an error message, the
status LED (5) of the device lights up red. The table
“
Input
bitrate
“ shows the current input bitrate of the IP source.
Ensure that the maximum bit rate of 80 Mbit/s is not exceeded. Otherwise the control connection of the device will
not be accessible.
The
“
Output bitrate
“ table displays the current output bit rate and the maximum bit rate allowed for the selected
modulation and per output channel. If the value is exceeded, a bit rate overflow will occur and the TV screen will
show pixel effects on the display.
The
“
Common status
“ displays additional status parameters of the device. The parameter “Processor load“
Summary of Contents for HDI 2 multi
Page 1: ...1 HDI 2 multi IP Modulator IP into DVB C DVB T ISDB T Manual 0902252 V1...
Page 22: ...22 Notes...
Page 23: ...23 Notes...
