24
Hand programming of the device
LCD Screen after switch on:
1. Shows the modulation of the output signal
2. Output frequency
3. Data rate of the output signal
4. Not relevant
Over view Main menu:
The main menu occurs after push
ing the button “Menu”.
Menu navigation by using arrow buttons.
Setting conf
irmation by “Enter”.
One step back
through pushing button “Back”
1.
Alarm Status
If there is no signal at the input,
the menu point “Alarm Status” will be shown: “No video in”
and the alarm indicator (9) turns on. This lights also red if a bit rate overflow occurs at the
output.
Start up
…
Start ok
…
Cable 750.00MHz
0.000 Mbps 0.0M
1
2
4
3
3 Modulator
4 TS config
5 Network
6 System
1 Status
2 Input sets