PolyVision
7
Using
ē
no interactive whiteboards
Unpairing the
ē
no stylus from your computer
The
ē
no stylus Bluetooth signal pairs with only one computer at a time. To
use the
ē
no stylus with a different computer that is in the same room, you
need to unpair it from the original computer before you pair it with a new
computer.
If the stylus is paired to a computer that has the PolyVision Bluetooth
adapter is plugged in, or if the computer uses built-in Windows Bluetooth
capability, you can unpair the stylus using the PolyVision driver.
To unpair the
ē
no stylus from the computer using the PolyVision driver:
1. On the paired computer, click the PolyVision icon in the system tray
(Windows) or system menu (Macintosh).
2. Choose “Configure the PolyVision driver” from the menu.
3. Click the “Hardware” tab.
4. Turn on the
ē
no stylus by removing its cap, then click “Remove
ē
no
stylus.”
note:
NOTE:
If you have a Macintosh with operating system 10.3.9, follow the steps you
would normally use to remove hardware on the computer.
If you are using third-party Bluetooth capability, unpair the stylus using
instructions provided by your product. The stylus is listed as device ADP-
301.
Getting started in projection mode
To set up the projector and get started projecting your computer on the
whiteboard:
1. Locate your projector’s video cable and connect it to the video port
of your computer.
2. Connect the other end of the video cable to your projector.
3. Connect the projector’s power cord to an outlet.
4. Turn on the projector and focus your computer screen squarely onto
your whiteboard. The projected image does not need to fill the white
area.
9A67)DQQMHO2CIG(TKFC[,WPG#/