PolyVision
37
Using Walk-and-Talk products
Cursor control in projection mode
You can use your finger as both a pen or cursor in projection mode.
Walk-and-Talk enables you to write or to navigate the projected computer
screen using either:
Ŗ
your finger on the whiteboard
Ŗ
the remote control buttons and touch pad
note:
NOTE:
If you use the Walk-and-Talk IP, use the remote control or the stylus.
To toggle between writing and cursor control:
Ŗ
press Cursor/Pen on the remote control
While using your finger as a cursor to control the computer from the
whiteboard:
Ŗ
To click, tap the whiteboard once.
Ŗ
To double-click, tap twice rapidly.
Ŗ
For a right-click (Windows) or control-click (Macintosh), hold your finger
to the whiteboard for one second.
To operate your computer with the remote control, point it toward the
infrared receiver on the Walk-and-Talk:
Ŗ
To click or double-click, press the “L” button or the click trigger, or tap
the touch pad on the remote control once or twice.
Ŗ
For a right-click (Windows) or control-click (Macintosh), press the “R”
button on the remote control.
Ŗ
To page up or down through a document, press the “Next” or “Previous”
button (for example, if PowerPoint is the active window, press “Next” to
move to the next slide).
For IP models, control your computer using remote control, or use the
stylus on the IP:
Ŗ
To click, tap the panel once.
Ŗ
To double-click, tap the panel twice rapidly or hover the stylus over the
display and press the stylus button furthest from the tip.
Ŗ
For a right-click (Windows) or control-click (Macintosh), hold the stylus
to the panel for one second, or hover the stylus over the panel and
press the stylus button near the tip.
9A67)DQQMHO2CIG(TKFC[,WPG#/