The Impulse System Maintenance
47
Impulse™ L
TX Multimedia Whiteboar
d System
T
HE
I
MPULSE
S
YSTEM
M
AINTENANCE
C
LEANING
THE
B
OARD
Wipe the control panel with a soft damp cloth.
To clean the ceramicsteel marker board surface, see instructions below or
refer to www.cleanmyboard.com.
Daily Care and Maintenance
1
For the initial cleaning, wipe your board with a clean cloth moistened
by a liquid cleanser.
2
Rinse with clear water. This step is simple but very important.
note:
NOTE:
Do not let water seep into the sensitive Impulse electronics. Your warranty
does not cover damage caused by water.
3
Wipe dry with a clean cloth.
4
If your board is used daily, the cleaning should be performed at least 2
to 3 times a week. More thorough cleaning may be required if writing is
left on the board for more than 2 days.
Removing Crayon and Tape
The same procedure is used to remove both crayon and tape.
1
Dampen a clean, dry cloth with water.
2
Sprinkle a small amount of non-abrasive cleaner, such as Scrub Soft,
onto the cloth.
3
Begin cleaning a small, manageable area using a back and forth
horizontal motion. Use normal pressure as if you were cleaning a
window.
4
Wipe off all residue with a dry cloth.
5
Rinse well with clear water. Please note that the rinsing and drying
steps are very important.
6
Wipe dry with a clean cloth.
LTX_UG_04.fm Page 47 Thursday, April 7, 2005 11:38 AM
