Automatic boiler for wood pellets
24
5
PUTTING THE PRODUCTS INTO OPERATION
5.1
CONNECTION TO THE SYSTEM
Connection to the system is performed in a usual manner - see the below given installation dimensions of products.
Recommended connection of the boiler to the heating system – see section picture.
Important:
With boilers KP 52S, KP 62S, KP 82S – it is important to have both water output connect!
Installation dimension of boiler – See APPENDIX 1 - Technical data of the boilers KP X2S
Filling the system with water takes also place in a standard way and the following principles have to be
adhered to at the same time:
Water for the heating system has to be clean, free from any admixtures.
If extremely hard water is used, there is a risk of "scale" formation - which is to the detriment of heat exchange and
causes tension in the boiler body and this tension may cause damage to the homogeneity of the body.
Attention!
Impurities and sediments which might jeopardize failure-free operation of pumps have to be thoroughly
rinsed before the system is finally filled with water.
5.2
INSTALLATION OF THE BURNER
The burner of the boiler is configured into one unit – the body of the screw gear unit + motor + 2
spirals for electric ignition including needful cable.
Burner has to be placed in a flange on the back side of the boiler and fasten it by nuts M 10 with washers so, that the
non-flammable rope is fitting evenly and very closely around circumference of the flange.
Connect the cable of the feeder F2 , of the fan. Place the fan in flange.
On the flange determined to a pellet supply connect by flexible hose and attach with fastener.
Insert a boiler thermostat sensor in to a tube placed on flange for pellet supply.
With burner KP52S, KP62S, KP82S attach a security thermostat by two straps on a pipe of the fuel input in to a burner.
Picture No. 17 Burner installation
Summary of Contents for KP 12S
