Setting Up Your Filter
12. Your ClariTec Filter is supplied with a
stepped hose tail to take a number of different
sized hoses. You should always use the largest
hose size possible to minimise flow loss in the
pipes through frictional loss. We recommend
using 1 1/4” (32mm) or 1 1/2” (37mm) hose.
PLEASE ENSURE
you cut off the smaller hose
sizes from your stepped hose tail that are not
being used.(A hack saw is recommended for
this) Failure to do this will result in significant
flow loss.
13. Place the stepped hose tail through the
female threaded nut, place your hose clamp
over the hose and then push your chosen hose
over the hose tail. The hose must always be
secured by a suitable clamp. Failure to do this
could result in the hose being pushed off by the
power of the pump. Fig 9
14. Once complete screw one hose tail onto the
outlet of your filter, marked with the arrow
pointing away from your filter (middle). And the
second onto the inlet marked with the arrow
facing towards the filter (left). Fig 10
9. Place the O-Ring in the channel at the top of
the canister. Fig 6
10. Line the waste removal pipe and delivery
pipe up with the two holes in the top of the
media basket. Press the lid of the unit down
firmly. Fig 7
11. Replace the clamping ring. Line the cutouts
in the clamping ring up with outlet, inlet and
waste removal outlet and close the clamping
ring. Fig 8
7
Fig 6
Fig 7
Fig 9
Fig 8
Fig 10
