background image

Make sure the filter is securely and correctly installed before switching on. 
Always disconnect the UV when not in use and when carrying out maintenance. 
Always disconnect all equipment in the pond before starting to handle, maintain, repair or 
install any pond equipment. 
The appliance is not intended for use by persons (including children) with reduced physical, 
sensory or mental capabilities, or lack of experience and knowledge, unless they have been 
given supervision or instruction concerning use of the appliance by a person responsible for 
their safety. 
Children should be supervised to ensure that they do not play with the appliance. 
For safety reasons, servicing or repair of this item should only be carried out by PondXpert. 
Never hang or carry the pump by the power cord. 
Do not operate the pump with a damaged cord or plug. The supply cord of the appliance 
cannot be replaced. 

 

If the electrical cord is damaged the product should be scrapped. 

 

Safety and Electrical Connections 

This unit is designed for outdoor use only. It is weatherproof and should be situated safely 
pondside. The filter should be sited where it cannot fall into the water or become 
waterlogged. 

NO PART OF THIS UNIT SHOULD EVER BE SUBMERGED IN WATER.

 

Direct exposure to UVC light can damage the eyes and skin. NEVER look directly at the 
UV when switched on. The translucent inlet will illuminate showing that the UV is working. 
Always disconnect all equipment in the pond before starting to handle, maintain, repair or 
install any pond equipment. 
 
The ultra violet clarifier housed within the filter is electrically operated so great care must be 
taken during installation and operation. The following electrical and safety guidelines must 
be carefully followed. 
 
Each filter is supplied with a length of 3 core electrical cable which is permanently 
connected to the ultra violet clarifier unit housed inside the filter. 

 

 
 
 
 
 
The termination to the mains supply should be permanent, inside a dry weatherproof 
enclosure, through a double pole switched fused spur with a minimum contact gap of 3mm – 
(disconnected) to BS 3676 – and fitted with a 3 or 5 amp fuse. 

The wires in the mains electrical lead are coloured in accordance with the 
following code: 
BLUE – Neutral (marked with an “N” in most terminal connections) 
BROWN – LIVE (marked with an “L” in most terminal connections) 
GREEN/YELLOW – EARTH (marked “E” or       in most terminal connections) 

1

st

 January 2005 revised Building Regulations for England and Wales 

Installing this product in the garden is classified as ‘notifiable’. The Regulations now require 
you to tell your local authority building control department that you intend to install this 
product before installation. Your local authority will let you know how you can get your 
installation approved 

Summary of Contents for SpinClean PXSC04500

Page 1: ...ns on the purchase of your pondXpert filter Once your filter is connected you can look forward to many years of healthy pond water Your filter is pump fed so must be connected to a suitable pond pump in order to work correctly Ideally a solids handling pump will be used as this will push dirty waste and debris into the filter PondXpert filters are carefully inspected and tested to ensure both safe...

Page 2: ... and skin NEVER look directly at the UV when switched on The translucent inlet will illuminate showing that the UV is working Always disconnect all equipment in the pond before starting to handle maintain repair or install any pond equipment The ultra violet clarifier housed within the filter is electrically operated so great care must be taken during installation and operation The following elect...

Page 3: ... 40mm 3 4 to 11 2 can be attached to the inlet hosetail Your pump and filter outlet should be positioned at opposite ends of the pond to promote maximum circulation Cut the inlet hose to the size appropriate to the size of hose you are using Then connect the hose from your pump to this inlet hosetail and secure with hose clips The translucent hosetail should be connected to the filter outlet as de...

Page 4: ...ration Spares and consumables The filter is supplied with everything you need to get started including filter media UV bulb and quartz tube for the UV Over time these parts may need replacing and can be purchased from your retailer Periods of operation Maintain filtration 24 hrs a day through the fish feeding season typically early March October when the water temperature is above 10 degrees C but...

Reviews: