2-59
Garage Door Opener Compartment
You can store and operate your garage door opener
in the third compartment of your overhead console.
To install your garage door opener, follow these
instructions:
1. Open the compartment by pressing the latch forward.
2. Remove the garage door opener button, by pressing
the tabs and pulling it down.
3. Remove the piece of self
-
sticking Velcro
R
from the
top of the garage door opener compartment.
4. Peel the protective backing from the Velcro and
press it firmly to the back of your garage door
opener.
5. Line up the button on the garage door opener with
the opening in the storage compartment door. Make
sure the garage door opener button is facing down
and then press the opener firmly into the garage door
opener compartment.
6. Once the opener is installed, remove the three pegs
from the garage door opener button. Each peg is a
different size.
7. Put the garage door opener button back in by
inserting the tabs into the slot in the garage door
opener compartment and test the peg.
8. Repeat this procedure until the correct peg length is
pressing the garage door opener button with the
compartment door closed.
Storage Compartment (If Equipped)
To open the storage compartment, located at the front of
the overhead console, press the release latch forward.
Then pull the compartment down to the full open
position.
Summary of Contents for 2002 Aztek
