2-84
Retro
-
Active Reset
The trip odometer has a feature called retro
-
active reset.
This feature can be used to set the trip odometer to the
number of miles (kilometers) driven since the ignition
was last turned on. This can be used if you forget to
reset your trip odometer at the beginning of a trip. To
use the retro
-
active reset feature, press and hold the
trip/reset button for at least three seconds. The trip
odometer will then display the number of miles
(kilometers) driven since the ignition was last turned on
and you began driving. (If you use the retro
-
active reset
feature after you have started the vehicle, but before you
begin moving, the display will show the number of
miles (kilometers) you drove during the last ignition
cycle.) Once you begin driving, the trip odometer will
accumulate mileage. For example, if you have driven
5.0 miles (8.0 km) since you started your vehicle,
and then activate the retro
-
active reset feature, the
display will show 5.0 miles (8.0 km). As you drive,
the display will then increase to 5.1 miles (8.2 km),
5.2 miles (8.4 km), etc.
Tachometer
The tachometer displays the
engine speed in revolutions
per minute (rpm).
NOTICE:
Do not operate the engine with the tachometer in
the red area, or engine damage may occur.
Summary of Contents for 2002 Aztek
