ALC Light Sensor
The ALC system’s light sensor is located
on top of the instrument panel. To
ensure proper system operation, it is
important to avoid placing any objects
on or near the sensor or covering up the
sensor, such as with an instrument
panel cover.
Exterior Lamp Control Switch
The exterior lamp control switch is
located on the lever to the left of the
steering column. The switch can be
rotated to each of the following four
positions:
(Headlamps):
Turns on the head-
lamps, parking lamps and taillamps.
(Parking Lamps):
Turns on parking
lamps and taillamps only.
AUTO:
Automatic Lamp Control
(ALC):
Automatically turns on Daytime
Running Lamps (DRLs) in the daytime,
and headlamps, parking lamps and tail-
lamps at dusk or when necessary.
(Off):
When operating in the
AUTO
position, a momentary turn of the lamp
control switch to the Off position will
turn off the ALC and all of the exterior
lights. The DIC will display an Automatic
Lights Off message. To activate ALC,
turn the switch again. ALC is always
turned on when the vehicle is started.
See Section 3 of your Owner Manual.
17
Owner
Information
Maintenance
Features
Convenience
Features
Instrument
Panel
Features
Audio
System
Features
Comfort Features
Remote
Keyless
Entry
System
CONVENIENCE FEATURES
Sunroof (if equipped)
The control switch for the sunroof is
located on the headliner between the
sun visors. It will operate only while the
ignition is on.
Vent Position
• Open the sunshade by hand.
• Press the rear part of the switch and
release it.
Fully Open Position
• Open the sunshade by hand.
• Press the rear part of the switch
twice and release it. The roof will
express-open all the way.
Closed Position
• Press the front part of the switch
and hold it until the roof closes.
• Close the sunshade by hand.
See Section 2 of your Owner Manual.
Window Indexing
(coupe/convertible only)
To provide a tight seal around the doors,
the window will automatically lower
slightly when the door is opened and
then automatically rise fully when the
door is closed.
Follow the Owner Manual procedure for
initializing the indexing feature if bat-
tery power is disconnected.
See Section 2 of your Owner Manual.
G6 2008 A 4/30/07 11:23 AM Page 17
