Step By Step Instructions
Repeat steps 34 - 35 on the opposite side of
the cover to pin the cover to the leading
edge on the other side.
Attaching the Leading Edge Tube
File the edges of the rope channel before
sliding it onto the rope hem of the cover.
On the side of the cover that hasn’t been
pulled in the track yet, slide the leading
edge tube on the rope hem along the front
edge of the cover. Pull tight on the cover to
help slide the leading edge bar onto the
cover.
Adjust the height of the wheel assembly
so the leading edge will clear any obsticles
near the pool such as slides and hand rails.
Repeat this step on the opposite side of
the cover.
Center the cover on the leading edge. Dis-
tribute the slack towards the center of the
leading edge. Make sure the corner gore is
upright and does not contact the pool deck.
Use caution when drilling near the cover.
Use a 5/32” bit to drill through the C-channel
of the leading edge. Do not drill through the
cover. Insert a #10 x 1/2” screw (26) to pin the
cover to the leading edge.
28
29
30
31
32
33
35
34
36
Numbers in parenthesis refer to parts shown on page 3.
Drill a minimum of three pilot holes evenly
spaced around the leading edge and into
the white dowel.
Insert screws (28) into each hole to connect
the leading edge to the wheel assembly.
Use a 1/2” wrench, to loosen the center bolt
of the wheel assembly. Repeat steps 27 - 29
on the opposite side of the cover.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
16 of 21
