Installation Checklist
Tracks
q
All track ends filed. This is extremely important.
q
Does the track space measurement match how the cover system was ordered?
q
Cover goes through the track joints smoothly.
q
All track screws are tight and flush.
q
Pulleys are flush against the end of the track.
q
The guides are snug against the end of the track.
q
Guides bolted in and are tight.
q
Splices used when joining the tracks together.
Mechanism
q
Mechanism installed level on the pool deck.
q
Tube level from side to side.
q
Enough clearance top, bottom, sides for the fabric. No rubbing of webbing on the pool deck.
q
Tube at the right height.
q
System mounted at right angle to the track.
q
Ropes coming back straight out of the track. An excessive angle will cause wear on the cover guides at the end of the track.
q
Ropes are not rubbing on the pool deck.
q
Ropes are run correctly.
q
8 feet of rope left on rope reel.
q
System bonded according to electrical code. Cover bonded to leading edge and roll-up tube.
Cover
q
Fabric pinned to the roll-up tube without pinned folds.
q
Cover runs smoothly.
q
Cover properly aligned when it closes or retracts. Note: An inch or two out of square is not uncommon and is not a
concer
n as it will not eff
ect the operation of the cover. Because of the size of the fabric roll, and changes in operating
conditions the cover may vary slightly in alignment as it is run.
q
The leading edge dowels move in and out freely the whole length of the pool.
q
Cover does not rub on the pool deck as it rolls up.
Misc.
q
Key switch is in full view of the pool.
q
Cover pump tested by putting it in the water and operate it in front of homeowner.
q
Pool area cleaned up.
q
Homeowner has been instructed.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
21 of 21
L040
4
1/
2
1/1
9
bm
