Step By Step Instructions
Use a hammer to tap the screw head down
until the anchor is flush with the top of the
pool deck.
11
Use the provided screws (29), anchors (16)
and snap-locks (30) to secure the track to
the pool deck.
Place the screw, anchor and snap-locks in
each hole.
10
Using a #3 Phillips bit, tighten the screw to
secure the snap-lock to the pool deck.
Make sure the beveled edge is facing the
water side of the pool.
12
Using a rubber mallet, strike the center of
the track to secure it to the snap-locks.
Be sure the track is flush with the pool
deck.
14
Position the track over the snap-locks. The
water side of the track will snap over the
beveled edge of the snap-locks. Make sure
the track is positioned correctly in relation
to the mechanism.
Using the guide (12) as a template, position
it on the end of the track. Mark the center of
the mounting hole.
Remove the guide from the track.
17
Insert the guide on the end of the track at
the mechanism end. The bottom half of the
guide is keyed to hold the nut in place. Using
a 5/32” allen wrench, tighten the screw on
the top of the guide (12).
Note: To prevent seizing, use anti-seize on
the nut and galvanic corrosion film on the
track before securing the guide to track.
Use a drill with a 5/32” bit to drill through the
track where it was marked in step 16.
Do this for the track on both sides of the pool.
18
13
16
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Numbers in parenthesis refer to parts shown on page 3.
Repeat attaching the track to the snap-locks
on the other side of the pool.
15
6 of 21
