Poolspa Laguna SPA, Installation And User Manual

11

Ready in Rest Mode
Heating

Shortcuts

Jets 3

Jets 2

Jets 1

Light

Back

1.5.3. THE SETTINGS SCREEN

The Settings Screen is where all programming and other spa behaviors are controlled.

This screen has several features that can be acted on directly. These features include Temp Range, Heat 

Mode, and Invert Panel. When one of these items is highlighted, the Select Button is used to toggle between 

two settings.

All other menu items (with an arrow pointing to the right) go to another level in the menu.

Press-and-Hold

If an Up or Down button is pressed and held when an item in a Menu List is highlighted, the list can be scrolled 

quickly from top to bottom. The scroll bar on the right side of the screen indicates the relative position of the 

highlighted item in the list.

Settings

Back

Temp Range

Heat Mode
Time of Day
Filter Cycles
Light Cycle
Invert Panel
Lock

High

Ready

Normal

Temperature Ranges

This system incorporates two temperature range settings with independent set temperatures. The specific 

range can be selected on the Settings screen and is visible on the Main Screen in the upper right corner of 

the display.

These ranges can be used for various reasons, with a common use being a “ready to use” setting vs. a 

“vacation” setting. Each range maintains its own set temperature as programmed by the user. This way, when 

a range is chosen, the spa will heat to the set temperature associated with that range.

High Range can be set between 26,5 °C and 40 °C.

Low Range can be set between 10 °C and 26,5 °C.

Freeze Protection is active in either range.

Heat Mode

To heat the water in the bath the pump has to feed water to the heater. The pump responsible for the operation 

is called a filtration pump. The heat pump can be either a two-speed (Pump 1) or a single-speed pump.

If the filtration pump is a two-speed pump 1, water will be supplied in the Ready mode every 30 minutes 

with the pump 1 operating at low speed (Pump 1 low) to ensure a constant water temperature. If necessary, 

the water will be heated and the temperature displayed on the screen will be updated. In the Rest mode the 

heating is carried out during the programmed filtration cycles only. When in the Rest mode, the temperature 

displayed on the screen may not reflect the current water temperature and the value will be updated after 1 - 

2 minutes of the filtration pump operation. While you can turn on or off the pump 1 operating with high speed 

[Pump 1 High], the pump 1 operating with low speed [Pump 1 Low] will run continuously and turn off once the 

desired temperature is reached or after 1 hour from the activation.