Poolspa SPA Marina, Installation And User Manual

  11

1.5.9. Increasing the maximum temperature

This function allows the user to increase the water temperature by two degrees centigrade above 
40°C (104°F). To set the temperature above 40°C, set the maximum temperature and next press 

and hold the up arrow button 

 for 5 seconds until the 

Orx.x

 sign appears on the display, where

x.x signifi es how much the temperature value is to be increased above the maximum temperature. This 
value can be increased half a degree, and the maximum value is two grades, so the maximum water 
temperature is 42° C. To return to a normal mode of setting the water temperature, press the down arrow 

button 

 a few times until the normal temperature, ranging from 15 to 40°C, appears on the display.

1.5.10. “Stand-By” function

This function blocks access to all devices connected to the controller for 60 minutes. This function 
stop all functions without need of disconnecting the power supply. To switch off this function, press 

this button 

 5 seconds. After switching this function on, the “Sby” sign will appear together with 

the time left to the end of this function. 
There are three methods to end this function:

●

 Wait 60 minutes until this function stops working.

●

 Press this button 

 for longer than 5 seconds when the function works.

●

 Disconnect the controller from the power supply.

The “Stand-By” function blocks the fi ltration function. If 40 minutes after going out from “Stand-By” 
mode SPA still will be in fi ltration period Filtration mode will start again.

1.5.11. Control panel keyboard locking

Partial keyboard locking:

●

 Press and hold this button 

. During this operation, the key-shaped icon blinks.

●

 The 

LocP

 sign will appear on the display after pressing this button on the control panel for 3 

seconds. Once this sign has appeared, the function becomes active and the key icon is on perma-
nently. The control panel is locked.

●

 Release the button (only jets, light, air/aux).

To unlock the panel, press and hold this button 

 for not less than 5 seconds.

The 

LocP

 sign will appear on the display if any button is pressed after locking the keyboard. The 

partial keyboard locking function is not remembered after a power cut-off. 

Total keyboard locking:

●

 Press and hold this button 

. The key-shaped icon blinks during this operation.

●

 The “LocP” sign will appear on the display after pressing this button on the control panel for 3 

seconds. Once this sign has appeared, the function becomes active and the key icon is on perma-
nently. The control panel is locked (all of the buttons).

●

 Keep this button pressed.

●

 After 5 seconds the 

LocF

 sign appears, and since that moment the function is active.

●

 Release the button.

To unlock the panel, press and hold this button 

 for not less than 5 seconds.

The 

LocF

 sign will appear on the display if any of the locked buttons is pressed after locking the