Page
16 of 25
POP-UP PUSH 8 ECO
Operator’s Safety and Maintenance Handbook ( rev.0.0.1.0210)
Section 5
MAINTENANCE
Periodical maintenance and checks
(continued)
Prior to first use of the
POP-UP PUSH 8 ECO
, all daily/pre-use checks must be
undertaken. If the machine has been in storage for a long period of time, it may
be necessary to undertake additional checks and tests as per the table on the
preceding page (e.g. lubrication, hydraulic oil, battery condition).
The Lifting Operations and Lifting Equipment Regulations 1998 (LOLER) require
that lifting equipment for lifting persons must be THOROUGHLY EXAMINED every
six months.
Following any maintenance on the
POP-UP PUSH 8 ECO
, a full function test
should be undertaken to ensure correct operation of the machine.
It is essential that only manufacturer’s approved replacement parts are used when
maintaining and servicing the
POP-UP PUSH 8 ECO
. Failure to do so may result in
an unsafe or unstable machine.
Storage
The electrical components of this
POP-UP PUSH 8 ECO
are not protected from ex-
ternal weather conditions and the machine should therefore not be stored outdoors.
Storage in a clean, dry indoor environment is recommended.
Frequent checks on the condition of the machine should be made to ensure no
excessive deterioration occurs due to the environment in which the machine is
housed.
Lubrication
The required lubrication points are shown opposite.
Lubrication points are to be found on the end of the scissor pack at both
ends of the machine.
The lubricant recommended for use with this
POP-UP PUSH 8 ECO
is:
standard machine grease
