68
// Popcorn Hour A-210
3. Restart the unit.
Note: To restart the unit, press the POWER button for 3 seconds to allow the internal HDD (if installed) to
turn off. Once the POWER button ring light turns red, switch the unit off using the Power
ON/OFF
switch
at the rear
panel and unplu
gging the power cord. Wait for 60 seconds before reconnecting the power cord
and switching the unit on using the Power
ON/OFF
switch. Press the POWER button to start the NMT. Once
the Media Source screen appears on your TV, the restart is completed.
4. Ensure that your NMT is connected to the Internet.
5. Go to
Setup > Maintenance > Update
and select
Check for Firmware Update
.
6. Allow the unit to check for updates and perform them if there are updates available
(this may take up to a few hours depending on your Internet connection speed and bandwidth).
7. Your NMT will restart when the update is completed and the NMT Applications Setup will begin
if you have an internal HDD installed.
