07-10-2020 09
:
28
Pagina 2 van 5
http://manual.zwave.eu/backend/make.php?lang=en&sku=POPE701486
To reset the device to the delivery state, the key is held down for 10 seconds. The device confirms a successful reset with a signal tone.
Safety Warning for Mains Powered Devices
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the
assembly of the product, the voltage network has to be switched off and ensured against re-switching.
Installation
Please use the installation instructions for the smoke detector (basic unit) for information on how and where the smoke detector should be installed. These
installation instructions comply with the European standard DIN EN 14676.
(1) Battery compartment
(2) Interlock
(3) Inclusion button
(4) Connector for supplying the printed circuit board
(5) Connection point for separate power supply
Remove the bottom of the housing by turning it counterclockwise.
Place the base where you want to attach the smoke detector. Draw a mark in each hole for the dowel and screw. Drill a hole (5mm drill) in each mark and
insert the plug. Then screw the floor tight.
Insert a battery and close the flap again.
The optional external power supply is connected to the connector (5). The internal battery must remain in the smoke detector even if an external power
source is connected.
Attach the smoke detector to the bolted base. Make sure that the hooks are correctly seated (arrows in the above picture). If the smoke detector is not
correctly positioned on the ring, you will notice that it cannot be turned properly.
Please follow the recommendations given to ensure maximum safety. Avoid placing the smoke detector in corners, but find a central place.
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be
added to an existing wireless network
to communicate with the
devices of this network. This process is called
Inclusion
.
Devices can also be removed from a network. This process is called
Exclusion
. Both processes are initiated by the primary controller of the Z-Wave network. This
controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Inclusion
1. insert the battery into the smoke detector
2. press the button (3) for one second
3. the safe inclusion starts while the LED flashes.
Exclusion
1. press the button on the circuit board once
2. An acoustic tone confirms a successful exclusion.
Product Usage
If the smoke detector detects smoke, the siren will sound, the red LED will flash and a signal will be sent to the Z-Wave controller and all other smoke
detectors in the network. If the battery is running low, the smoke detector will beep briefly several times a day for 30 days.
