107
lysis
the trigger box warning lamp
will blink
Warning lamp does not glow:
Check battery charge state (refer to ‘Battery Installation’)
Check the cable connection to the firing buttons (refer to ‘Trigger
box wiring harness’)
Check fire button function
Remove the trigger box cover and change the battery. Ensure
Checking the firing button:
Attention: The toggle switch on the trigger box must be set in the ‘System
Inactive’ position.
Throw the toggle switch in the luggage compartment
If the switch is functioning correctly the trigger box warning lamp
will glow
Return the switch to the original position
Press the dashboard mounted push button
If the switch is functioning correctly the trigger box warning lamp
will glow
Trigger box connection:
The firing button ‘1’ is connected to the terminals ‘3’ and ‘4’, firing button
‘2’ with the terminals ‘5’ and ‘6’.
Incorrectly connected cables accidentally can fire the
extinguisher system.
9.4.2.
Extinguisher system error ana
Battery check:
Hold the toggle switch on the trigger box in the “Battery Check”
position
If the battery charge state is good
Battery installation:
Attention: The toggle switch on the trigger box must be set in the ‘System
Inactive’ position.
that the battery poles are connected correctly. Only Alkaline
batteries should be used.
Summary of Contents for 911 GT3R 2010
