COM-CENTER START
1) Attach AC power cord to Com-Center, then plug into the nearest wall outlet.
2) If a wall outlet is not available insert rechargeable battery into slot at back of
Com-Centers
(silver contacts must be in proper position).
3) OR use five brand name AA batteries in battery sled
(provided).
4) Turn Com-Center ON
(switch on back panel).
Operation
ALL-IN-ONE SERIES START-UP
1) Insert battery into headset. Headset will
automatically turn ON.
HEADSET CONTROLS
1) POWER BUTTON
– After the battery is installed, the power button is used to
turn the headset ON and OFF.
OFF by pressing and holding until LED goes out.
ON by quick clicking, LED illuminates.
Power
Volume
MIC Mute
2) VOLUME
- Volume control buttons adjust to any of five settings.
3) MIC Mute – Grey Button
Click MIC button to mute microphone – audible tone confirms change.
Note: Repetitive beep indicates low battery.
IMPORTANT TIPS
Microphone Placement
COMSTAR headsets include a special noise cancelling
microphone. For optimum performance place directly in
front of, and appx. 1 – 2 “ from mouth.
Rain Game / Storage
Place the Com-Center in a protected dry location during use. Before storing,
wipe down all equipment and leave out in a well ventilated room to fully dry.
Do not store in bags or carrying case when wet.
Compartment on unit bottom houses switches for factory programming. Call Porta Phone Co. for more information.
BLUE LED INDICATIONS
1) Flashing blue LED on headset indicates automatic tuning to Com-Center
signal.
2) When the Com-Center is ON the headset LED will change to solid blue –
ready for communication.
