PMP400 USER MANUAL
Portable Electronics Ltd © 2008
4/27
1 Safety and storage guide
Vibration, moisture, electro-magnetism, extreme low/high temperature and direct
sunlight exposure to the player and the remote controller must be avoided to prevent
damage.
Prolonged use of the device may cause permanent hearing loss and/or eye problems.
To protect your sight and hearing, please keep the volume low and do not use it
continuously for extended hours.
Do not attempt to take apart, open, service, or modify the product or power supply.
Doing so could present the risk of electric shock or other hazard. Any evidence of any
attempt to open and/or modify the device, including any peeling, puncturing, or removal
of any of the labels, will void the Limited Warranty.
Clean only with soft dry cloth while the player is turned off.
Do not charge the battery for extended hours to prevent potential fire hazard.
2 Charging the battery
Fully charge the battery (5 – 6 hours) before using it for the first time.
Use ONLY the designated charger for the PMP400. You can charge the internal battery
of PMP400 by plugging the included charger into the device or using a standard USB
port.
Using Non-designated charger may damage the PMP400
The red CHARGE indicator lights up to indicate that the external adapter is connected,
the battery will charge automatically when the AC adaptor is plugged in, the light will
disappear once the battery is fully charged.
Disconnect the charger when fully charged.
3 Turning on/off the PMP400
1. Hold the POWER
button for 5 seconds till you see the word PMP appears. After that,
you will see a splash screen that says “ALL-IN-ONE” and then the PMP is ready to use.
2. If the unit shuts off automatically after holding the POWER
button for several
seconds, the unit is out of power. Please plug in the charger to charge the battery.
3. There is a build-in screen saver function to save battery power. If the PMP400 is not
being used, the screen will shut off automatically in order to save battery life.
4. To turn off the unit, press and hold the POWER
button for 5 seconds till the PMP
says “Power off, please wait…”
4 Hardware Reset
In the unfortunate event that the PMP400 freezes or hangs and does not respond, you can
force the unit to shut down by inserting a needle to press the RESET hole at the bottom.
