Porta
Switch
Prepaid WiFi Services
© 2000-2011 PortaOne, Inc. All rights Reserved. www.portaone.com
10
2.
Connect to Mikrotik.
ssh admin@192.186.0.21
NOTE: Replace 192.168.0.21 with Mikrotik IP address:
3.
Assign IP address to wlan1 interface.
[admin@Mikrotik] > /ip address add interface=wlan1 address=192.168.12.1
netmask=255.255.255.0 disabled=no
[adimn@Mikrotik] > / address print
Flags: X – disabled, I – invalid, D – dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 D 192.168.0.214/24 192.168.0.0 192.168.0.255 ether1
1 192.168.12.1/24 192.168.12.0 192.168.12.255 wlan1
[admin@MikroTik] >
NOTE: Network “192.168.12.0/24” is used as a sample.
4.
Enable wlan1 interface and set wireless to “access
point-bridge” mode.
[admin@Mikrotik] > /interface enable wlan1
[admin@Mikrotik] > /interface print
Flags: X – disabled, D – dynamic, R - running
# NAME TYPE RX-RATE TX_RATE
MTU
0 R ether1
ether
0
0
1500
1 R ether2
ether
0
0
1500
2 R ether3
ether
0
0
1500
3 R wlan1
wlan
0
0
1500
[admin@Mikrotik] >
[admin@Mikrotik] > /interface wireless print
Flags: X – disabled, R – running
0
name="wlan1" mtu=1500 mac-address=00:0C:42:05:7A:B6 arp=enabled
disable-running-check=no interface-type=Atheros AR5413
radio-name="000C42057AB6" mode=station ssid="MikroTik" area=""
frequency-mode=manual-txpower country=no_country_set antenna-gain=0
frequency=5180 band=5ghz scan-list=default rate-set=default
supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps supported-rates-
a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,54Mbps
basic-
rates--b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007 ack-
timeout=dynamic tx-power-mode=default noise-floor-threshold=default
periodic-calibration=default periodic-calibration-interval=60 burst-
time=disabled dfs-mode=none antenna-mode=ant-a wds-mode=disabled
wds-default-bridge=none wds-default-cost=100 wds-cost-range=50-150
wds-ignore-ssid=no update-stats-interval=disabled default-
authentication=ye
default-forwarding=yes default-ap-tx-limit=0