3
Before use, inspect the entire machine for loose parts (nuts, bolts, screws etc) and any
damage. Repair or replace as necessary before using this machine.
DO NOT USE
any attachment with this power head other than the ones recommended by
Portek. Serious injury to the operator or bystanders could result as well as damage to the
machine.
Keep the handles free from oil and fuel
Do not smoke while mixing fuel or filling tank.
Do not mix fuel in an enclosed room or near open flames. Assure adequate
ventilation.
Always mix and store the fuel in a properly marked container that is approved by
local codes and ordinances for such usage.
Never remove the fuel tank cap while the engine is running.
Never start or run the engine inside a closed room or building. Fumes from the
exhaust contain dangerous carbon monoxide.
Never attempt to make engine adjustments while the unit is running. Always make
engine adjustments with the unit resting on a flat, clear surface.
REMOVE SPARK
PLUG LEAD TO PREVENT ACCIDENTAL STARTING
Do not use the unit if it is damaged or poorly adjusted. Never remove the
machine’s guard.
Inspect the area to be cut and remove all debris that could become entangled in the nylon
cutting head. Also remove any objects that the unit may throw during cutting.
Keep children away. Onlookers should be kept at a safe distance from the work area,
at least 15metres/50 feet.
Never leave the machine unattended.
Do not use this unit for any job other than those for which it is intended as described
in this manual.
Do not overreach. Keep proper footing and balance at all times. Do not run the unit while
standing on a ladder or on any other unstable footing location.
Keep hands and feet clear of the nylon cutting head while unit is in use.
Do not use this type of machine for sweeping away debris.
Do not use the unit when you are tired or under the influence of medication, drugs or alcohol.
Important safety information
!
!
!
!
!
!
