4
Important safety information
NEVER
use a damaged strimmer head. If a stone or any other obstacle is hit, stop the
engine and check the nylon cutting head. A broken or unbalanced nylon cutting head
must never be used.
FOLLOW INSTRUCTIONS FOR CHANGING ACCESSORIES.
Do not store in a closed area where fuel vapours can reach an open flame from hot water
heaters, furnaces etc. Store in a locked, well ventilated area only.
Use only PORTEK equipment parts when servicing the unit, this will ensure safe and proper
performance of your product. These parts are available from your dealer. The use of any other
accessories or attachments may cause a potential hazard to the user, damage to the machine
and void this warranty.
When refuelling, be sure to stop the engine.
NEVER
refuel when the engine is running or has
overheated. When gasoline spills, be sure to wipe it up completely and properly dispose of
those materials before starting the engine.
Stay clear of other workers or bystanders by at least 15 metres/50 feet.
Whenever approaching an operator of the machine, carefully call his attention and confirm the
operator stops the engine. Be careful not to startle or distract the operator which can cause an
unsafe situation.
Never touch the nylon cutting head whenever the engine is running. If it is necessary to adjust
the protector or nylon cutting head, be sure to stop the engine and confirm that the nylon
cutting head has stopped running.
The engine should be turned off when the machine is moved between work areas.
Be careful not to hit the nylon cutting head against stones or the ground.
Unreasonable rough operation will shorten the life of the machine as well as create
an unsafe environment for yourself and those around you.
Pay attention to loosening and overheating of parts. If there is any abnormality of the machine,
stop operation immediately and check that machine carefully. If necessary, have the machine
serviced by an authorised dealer. Never continue to operate a machine which may be
malfunctioning.
In start-up or during operation of the engine, never touch hot parts such as the muffler, the
high voltage wire or the spark plug.
After the engine has stopped, the muffler is still hot. Never place the machine in any places
where there are flammable materials (dry grass etc) combustible gasses or combustible liquids.
AFTER USE
Clean the machine completely, especially the fuel tank, its surroundings and the air cleaner.
!
!
