6
Assembly & Operation
ASSEMBLY
The following steps are given as a guide to assemble your SprayMaxx sprayer:
1. Check inside the tank for any foreign objects.
2. Remove the pressure gauge from parts bag and fit onto sprayer.
3. Fit lid on top of the tank.
OPERATION
The following steps are given as a guide to operate your SprayMaxx sprayer:
• When mounting the sprayer to a vehicle using the ratchet tie-down straps, check that the
spray tank is still secure after the first 15 minutes of operation and re-tighten as necessary.
• Partially fill the tank with clean water.
• Connect the battery clips to a 12V DC power supply (red to the positive terminal, black to
the negative terminal) ensuring sufficient current capability (amps) to suit the pump. The
pump’s maximum amperage requirement can be found on its name plate.
• In order to prime the system and enable the pump to reach full pressure, depress the hand
lance trigger to release any trapped air. The pump may automatically switch off when the
hand lance trigger is released.
• Pump cycling may occur with insufficient nozzle delivery. This continual switching on and off
will reduce the battery and motor life. Should this occur, adjust the setting of the nozzle tip
or the regulator until the cycling stops.
