11
ON BOARD BIT STORAGE
A bit storage slot is built-in to the area just above the battery.
TROUBLESHOOTING
Problem
Possible Cause
Possible Solution
• Unit will not start.
• Battery pack not installed properly.
• Check battery pack
installation.
• Battery pack not charged.
• Check battery pack
charging requirements.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
charger until LED
appears.
• Charger not plugged in.
• Plug charger into a
working outlet. Refer to
“Important Charging Notes”
for more details.
• Surrounding air temperature
• Move charger and battery
too hot or too cold.
pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
SPECIAL NOTES FOR USE WITH LITHIUM BATTERIES
• Unit shuts off abruptly.
• Battery pack has reached its
• Allow battery pack to cool
maximum thermal limit.
down.
• Out of charge. (
To
• Place on charger and
maximize the life of the
allow to charge.
battery pack it is designed
to shutoff abruptly when
the charge is depleted.
)
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
LI-ION or NI-CD battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
PORTER-CABLE.
RBRC™ in cooperation with PORTER-CABLE and other battery users, has
established programs in the United States to facilitate the collection of spent LI-
ION or NI-CD batteries. Help protect our environment and conserve natural
resources by returning the spent LI-ION or NI-CD battery to an authorized
PORTER-CABLE service center or to your local retailer for recycling. You may
also contact your local recycling center for information on where to drop off the spent
battery.
RBRC™ is a registered trademark of the
Rechargeable Battery Recycling Corporation.
MAINTENANCE
Cleaning
With the motor running, blow dirt and dust out of all air vents with dry air. Wear safety
glasses when performing this procedure. Exterior plastic parts may be cleaned with a
damp cloth and mild detergent. Although these parts are highly solvent resistant,
NEVER use solvents.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
90550107 PC1800ID, PC1200ID 4/1/09 9:33 AM Page 11
