• TO REMOVE BATTERY PACK: Depress the battery
release button as shown in
figure D
and pull battery
pack out of tool.
Operating Instructions
TO MAINTAIN SAFE TOOL CONTROL
•
Make sure the work surface is free of nails or screws.
Cutting into a nail or screw
may cause the tool to jump, damaging the bit.
•
Never operate the tool with one hand while holding the workpiece with the other
hand.
Always clamp the material and guide the tool with both hands.
•
Do not cut material lying on a hard surface
. Clearance behind material to be cut
must be allowed for protruding bit.
•
Disconnect battery from tool
before making adjustments, changing bits, or cleaning
tool.
•
Do not start the tool with bit engaged in the material.
The bit may grab the material.
ON/OFF SLIDER SWITCH (FIGURE E)
To start the motor, slide the on/off slider switch to “I”
position. To stop the motor, slide the switch to “O”
position.
DEPTH GUIDE
Laceration Hazard. Turn off tool and remove battery before making
any adjustments or removing/installing attachments or accessories.
Keep depth guide in place at all times during operation of the tool. For best results, adjust
the guide using knobs to allow the bit to protrude about 1/8 in. past the material to be cut.
INSTALLING AND REMOVING THE BIT (FIGURES F, G)
Laceration Hazard. Turn off tool and remove battery before making
any adjustments or removing/installing attachments or accessories.
1. Remove the depth guide using the end of the
supplied wrench as shown in
figure F
.
:
:
10
D
E
F
90562807 PC1800SS rotary saw.qxd:??????-00 Cir Saw book 3/24/10 8:27 AM Page 10
