Porter-Cable CL180PS, Instruction Manual

4

ADDITIONAL SPECIFIC SAFETY RULES

1.

ALWAYS disconnect the sander from the power source before changing

abrasive sheets.
2.

USE PROPER SAFETY EQUIPMENT. Wear safety goggles to protect

your eyes and wear a protective mask to minimize breathing in the fine dust
created while sanding. NOTE: Some wood contains preservatives which can
be toxic. Take extra care to prevent inhalation and skin contact when work-
ing with these materials.
3.

SANDING OF LEAD BASED-PAINT IS NOT RECOMMENDED. Lead-

based paint should only be removed by a professional.
4.

Some wood contains preservatives which can be toxic. Take extra

care to prevent inhalation and skin contact when working with these materi-
als. Request, and follow, any safety information available from your material
supplier.

Technical Service Manager
Delta Machinery
4825 Highway 45 North
Jackson, TN 38305

There are certain applications for which this tool was

designed. Delta strongly recommends that this tool NOT be modified and/or used
for any application other than for which it was designed. If you have any questions
relative to its application DO NOT use the tool until you have written Delta and we
have advised you.

SYMBOL

DEFINITION

V

........................ volts

A

........................ amperes

Hz

........................ hertz

W

........................ watts

kW

........................ kilowatts

µF

........................ microfarads

l

........................ liters

kg

........................ kilograms

N/cm

2

........................ newtons per square centimeter

Pa

........................ pascals

h

........................ hours

min

........................ minutes

s

........................ seconds

........................ alternating current

3  

........................ three-phase alternating current

3

N

........................ three-phase alternating current with neutral

........................ direct current

n

0

........................ no load

........................ alternating or direct current

...................... Class II Construction

SYMBOLS