11
WARNING:
Keep fingers AWAY from trigger when not driving fasteners to
avoid accidental firing.
NEVER
carry tool with finger on trigger.
1. Wear proper eye, hearing and respiratory protection.
2. Remove battery pack from tool and engage trigger lock-off.
3. Lock the pusher in the back position and remove all nail strips from the magazine.
4. Check for smooth and proper operation of contact trip and pusher assemblies. Do
not use tool if either assembly is not functioning properly.
5.
NEVER
use a tool that has damaged parts.
TO OPERATE THE NAILER
WARNING:
The contact trip needs to be depressed followed by a full trigger pull
for each nail followed by a release of both the contact trip and trigger after each nail.
WARNING:
The battery should always be removed and the trigger lock-off
engaged whenever any adjustments are made or when tool is not in use.
1. Fully depress contact trip against the work surface.
2. Fully pull trigger and motor will start. (nail will drive into work surface).
3. Release trigger.
4. Lift contact trip off work surface.
5. Repeat steps 1 through 4 for next application.
PREPARING THE TOOL
WARNING:
NEVER spray or in any other way apply oil, lubricants or cleaning
solvents inside the tool.
This can seriously affect the life and performance of the tool.
WARNING:
The battery should always be removed and the trigger lock-off
engaged whenever any adjustments are made or when tool is not in use.
1.
Read the Safety Instruction section of this manual.
2. Wear eye and ear protection.
3. Remove battery from tool and fully charge.
4. Ensure magazine is empty of all fasteners.
5. Check for smooth and proper operation of contact trip and pusher assemblies. Do
not use tool if either assembly is not functioning properly.
6. Keep tool pointed away from yourself and others.
7. Insert fully charged battery pack.
LOADING THE TOOL
WARNING:
Keep the tool pointed away from yourself and others. Serious
personal injury may result.
WARNING:
Never load nails with the contact trip or trigger activated. Personal
injury may result.
WARNING:
Always remove battery pack
before loading or unloading nails. Serious personal
injury may result.
WARNING:
The battery should always be
removed and the trigger lock-off is engaged
whenever any adjustments are made or when tool is
not in use.
CAUTION:
Keep fingers clear of pusher to
prevent injury.
1. Insert fasteners into the bottom of the magazine (9).
2. Pull pusher (10) downward until the nail follower
(D1) falls behind the nails as shown in
figure D
.
3. Release the pusher (10).
D
10
12
9
D1
